Preventing Water Damage

Water damage Utah from floods can cause significant property damage. There are many remedial measures that can be taken to mitigate or prevent any potential damages in the event of a flood. Damage to electrical systems can be prevented by raising electrical sockets, switches and circuit breakers, water heaters and furnaces by one foot or more above the projected flood level in the area in which it is located. Similarly, any outdoor equipment including air conditioning units, fuel tanks, and electrical generators should also be placed above the local flood level. Certainly, this equipment should not be sitting on the ground itself.

Inside the house from a plumbing perspective it is an easy step to install exterior and or interior backflow valves in order to prevent the accumulations of sewage in the house in the event of a flood. In addition, gate valves should be installed on all pipes that enter the house in order to prevent back flow because the have significantly stronger seals than standard backflow valves.

In many cases it can be informative to observe how any water tends to accumulate in and around a house during and after an average rainstorm. An accumulation of rain water in the street running along the front of a house is something that should be brought to the attention of the municipal or local environmental services department. The local environmental services department will have different titles depending on the particular jurisdiction. Regardless of the title, the service will be able to provide advice as to how to prevent or otherwise deal with an undesirable accumulation of water in order to avoid water damage Utah.

Finally, many home owners choose to install vents in the foundation of the house in order to allow water to flow in and out of the structure. This adaptation serves to prevent the accumulation of water inside the foundation. Typically two vents are installed in each wall respectively.

How Much Does it Cost to Replace Your Roof

Various kinds of roofing shingles are available. Asphalt is the most common one which costs $80 to $100 every square. A square is equal to one hundred square feet. The cedar shingles cost $160. Let’s assume the roof is 1300 to 1500 square feet. You will need 13 to 15 squares of shingles.

Breaking Down All Expenses

Which means the total cost is $1500. A roofing felt is needed which costs $18 per roll. Total cost of the roofing felt is $90. For attaching the materials together roofing nail gun is required. A roll of 1 1/4’’ galvanized nails cost $65. The roofing cement costs $22 every gallon. The contractor’s fee is $3 per square foot of work. So, overall asphalt shingles will cost $4500.

Installing wooden roof requires more work. First you need to remove the previous roofing and add plywood. The cost of removing the roof is the contractor’s fee which is $3 per square foot. About 20 plywood would be necessary, each costing $20, which is a total of $800. The cost of re-shingling with wooden material will cost $5 to $7 per square foot. So the total cost will be $10,500.

How Long Will It Take?

Time is a major factor that homeowners must consider within the cost of the project. Asphalt shingles are cheap and it is much convenient to install. But wooden shingles will last for 30 to 50 years. Wooden shingles are also more environment friendly and provides better installation.

If you are very short of budget then you can go for asphalt, else wooden materials are definitely better. The costs of materials vary now and then. You should contact an expert or a local contractor to know the exact cost of the materials so that you can estimate your budget. Hire a good roof expert, tell your budget and they will provide you the best solution.

Cost Guide

Source: http://www.aroconllc.com/blog/roofing-cost-guide